Affordable tool to avoid failed prints, by detecting a filament run-out. Can be easily used on a endstop header and most firmwares will support this feature.
This product comes with a meter long wire which connects to your electronics. Use the following wiring schema:
Detection is active-high, which means that the signal line will be high, when filament is detected. The detector is black and has a clear arrow marking for the filament direction, a small green led show that filament is detected. The sensor can be mounted using two 3mm holes, for example directly onto a cold-end.
|1 - 4:||excl € 5.99 incl € 7.19|
|5 - 9:||excl € 5.70 incl € 6.83|
|10 - 29:||excl € 5.54 incl € 6.65|
|30 - :||excl € 5.40 incl € 6.47|
|Need a larger quantity? Contact our Sales department.|