Duet 3 Tool Distribution Board
With this new board you can connect up to 4 Duet 3 Toolboards to the Duet 3 mainboard at one time! It has a 2-way barrier strip for Power in, four 2-way JST VH connectors, two RJ11 connectors for CAN bus in/out , four 4-pin JST ZH connectors, four pairs of 2-pin headers and a CAN bus termination 2-pin header. Want to know more about this amazing board then click here!
Rotating Magnetic Filament Monitor
We now have the Duet 3D filament monitor. You can connect it to your Duet 2 or 3 and it can detect multiple issues like:
The magnet rotation is sensed and constantly reported to Duet board what makes this monitor extremely accurate for a wide range of filaments. Click here to find out more!
Duet 3 Toolboard 1LC
This new Toolboard works with the Duet3D Mainboard. It is a CAN-FD connected expansion board that is designed to provide complete control for a direct drive extruder. You can fit the E3D Hemera on there, however it can be used with other direct drive extruders with suitable brackets too. You can connect the stepper motor, heater, temperature sensor, fans, filament monitor and optionally Z probe to this Toolboard what will result that only the CAN-FD and power wires run back to the Mainboard or Distribution board.
Want to find out more about its main features and the optional connector pack of this great Toolboard? Then click here!
Duet 3 Mini 5+
We now have the Mini 5+ in our assortment this slimmer version of the Duet 3 board is available in a Wifi and Ethernet version. IT is suitable for most 3D printers and upgradable with many available Duet 3 addons.
The board has a 32-vit ARM processor, provides 5 on-board drivers and has the normal complement of heater, fans, IO, LCD etc. This board has the option of using an SBC (Single Board Computer) for control in the same manner as other Duet 3 main boards. This Mini 5+ has a lot to offer you in it's small size, click here for the Wifi version and here for the ethernet one to find out more!